Type -
OR:
Diameter - none.
Photocathode - none.
Input Window - none.
Output Window - none.
Gateability - none.
Phosphor - none.
Type - none.
Interactive Specification
Write image intensifier type in field "Type" or set all type specifical parameters.
Logarithmic
Show sensitivity as table Show detection efficiency as table
-
Show sensitivity as table Show detection efficiency as table
| Wavelegth (nm) | Sensitivity (mA/W) | ||
| typical | min (*) | max (*) |
| Wavelegth (nm) | DE (%) | ||
| typical | min (*) | max (*) |
Gain measurement -
Logarithmic
-
Logarithmic
| Wavelegth (nm) | Gain (W/W) | ||
| typical | min (*) | max (*) |
Main parameters
| Parameter | min | max | typical | Note |
|---|---|---|---|---|
| Maximal spectral gain (W/W)(*) | ||||
| Resolution (lp/mm) | ||||
| EBI (µlx) | ||||
| Dark Emission Rate (el/cm2/sec) |
Phosphor -
Show all phosphors
Show all phosphors
Blemish Specification and Uniformity
Zones (diameter from center, mm)
| Zone 1 | Zone 2 | Zone 3 |
|---|---|---|
Number of Allowed Blemishes (<25µ-minimal,>150µ-0)
| Zone 1 | Zone 2 | Zone 3 | |||
|---|---|---|---|---|---|
| 25-75 µm | 75-150 µm | 25-75 µm | 75-150 µm | 25-75 µm | 75-150 µm |
The sum of all blemish areas not exceeds 1 % of the zone area.
With long blemishes the area is calculated using the area of an equivalent circle.
Bright spots visible with a microscope and dark adapted eyes are not allowed at the recommended intensifier voltages inside the useful area.
The local non-uniformity of luminous screens is less than (%) ±